22 Keysight E5061B Network Analyzer
Installation
Installing Front Handles/Rack Mounting Flanges
1-
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame
of the E5061B front panel.
Step 2. Use the screws provided to mount a rack-mounting flange (4) on each side of
the E5061B front panel frame.
Step 3. Remove the four bottom feet of the E5061B (lift the bar marked TAB on the
inner side of the foot and slide the foot toward the bar).
Step 4. Mount the E5061B on the rack.
How to Install the Rack-mount and Handle Kit (Option 1CP)
The rack-mount and handle kit includes both the rack-mounting flanges
(locking side plates) and front handles. While referring to Figure 1-3, install the
rack-mount kit by following these steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame
of the E5061B front panel.
Step 2. Use the screws provided to mount a front handle (2) and rack-mounting
flange (4) on each side of the E5061B front panel frame.
Step 1. Remove the four bottom feet of the E5061B (lift the bar marked TAB on the
inner side of the foot and slide the foot toward the bar).
Step 2. Mount the E5061B on the rack.
Use both a front handle and a rack-mounting flange in the same time
certainly. Do not attempt to install flanges or handles separately with
hardware provided. Serious electrical damage will occur to the instrument.
To Next Page
Loading...
Need help?
General
