39
Keysight E5061B Network Analyzer
Installation Guide
2 Troubleshooting
This chapter describes the troubleshooting process during start up and the
procedure of the operating system (OS) recovery when the Windows OS has
been damaged.
Troubleshooting during Startup
When you encounter problems during start up, see Table 2-1. System recovery
saves most of problems.
Table 2-1 Troubleshooting during startup
Symptom Solution
Turning on (|) the standby switch
does not start up the system.
Confirm that the power cable is
p ro p e r l y p l u g g e d i n .
Confirm that the line switch at the
rear panel is turned on.
The system starts up, but it
automatically shuts down
immediately.
Execute the system recovery.
The system starts up, but it enters
the service mode (The status bar at
the lower right of the screen displays
SVC in red).
The measurement screen appears
after start up, but the power-on test
fails with Error Message 241
prompting on a red background in
the instrument’s message/warning
area at the lower left of the screen.
To Next Page
Loading...
Need help?
General
