6 Keysight E5061B Network Analyzer
Caution
General Safety Precautions
-
General Safety Precautions
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these
precautions or with specific WARNINGS elsewhere in this manual may impair
the protection provided by the equipment. Such noncompliance would also
violate safety standards of design, manufacture, and intended use of the
instrument. Keysight Technologies assumes no liability for the customer’s
failure to comply with these precautions.
• Ground the Instrument
To avoid electric shock, the instrument chassis and cabinet must be grounded
with the supplied power cable’s grounding prong.
• Do NOT Operate in an Explosive Atmosphere
Do not operate the instrument in the presence of inflammable gases or fumes.
Operation of any electrical instrument in such an environment clearly
constitutes a safety hazard.
• Keep Away from Live Circuits
Operators must not remove instrument covers. Component replacement and
internal adjustments must be made by qualified maintenance personnel. Do
not replace components with the power cable connected. Under certain
conditions, dangerous voltage levels may remain even after the power cable
has been disconnected. To avoid injuries, always disconnect the power and
discharge circuits before touching them.
• DO NOT Service or Adjust the Instrument Alone
Do not attempt internal service or adjustment unless another person, capable
of rendering first aid and resuscitation, is present.
• Do NOT Substitute Parts or Modify the Instrument
To avoid the danger of introducing additional hazards, do not install substitute
parts or perform unauthorized modifications to the instrument. Return the
instrument to a Keysight Technologies Sales and Service Office for service and
repair to ensure that safety features are maintained in operational condition.
• Dangerous Procedure Warnings
The E5061B complies with INSTALLATION CATEGORY II as well as
POLLUTION DEGREE 2 in IEC61010-1. The E5061B is an INDOOR USE
product.
The LEDs in the E5061B are Class 1 in accordance with IEC60825-1,
CLASS 1 LED PRODUCT.
To Next Page
Loading...
Need help?
General
