Keysight Technologies P Series - Specifications; Introduction

1 Specifications
24 Keysight N8262A Service Guide
Introduction
This chapter details the power meter’s specifications and supplemental
characteristics
Specifications describe the warranted performance and apply after a 30 minute
warm-up. These specifications are valid over the power meter’s operating and
environmental range unless otherwise stated and after performing a zero and
calibration.
Supplemental characteristics, which are shown in italics, are intended to provide
information useful in applying the power meter by giving typical, but non
warranted performance parameters. These characteristics are shown in italics or
denoted as “attributes”, “nominal” or “approximate”.
For information on measurement uncertainty calculations, refer to Keysight
Application Note 64-1A, “Fundamentals of RF and Microwave Power
Measurements”, Literature 5965-6630.