Keysight CX3322A - Turning On;Off the CX3300; To Turn on the CX3300; To Turn off the CX3300

22 Keysight CX3300 User’s Guide, Edition 4
Setting Up the CX3300
Turning On/Off the CX3300
Turning On/Off the CX3300
Press the Standby switch to turn on or off the CX3300. The switch is located in
the lower left corner of the CX3300 front panel.
WARNING
Whenever it is likely that the ground protection is impaired, you must make the
instrument inoperative and secure it against any unintended operation.
To Turn On the CX3300
Press the Standby switch. After system boot up, self-test, and initialization, the
CX3300 displays the Main Waveform screen. The CX3300 is ready to use.
Even though the CX3300 has turned on, you can connect or disconnect the
CX1100.
NOTE
The CX3300 displays the time vs current graph for the channel enabled and
connected to the current sensor. However it displays the time vs voltage graph
for the channel enabled without the current sensor.
To Turn Off the CX3300
Press the Standby switch. The CX3300 will go through a normal Windows
operating system shutdown process.
CAUTION
If a DUT is connected to the CX3300, do not turn the CX3300 off to prevent
damage on the DUT.
Standby switch