Keysight Signal Generators Programming Guide 187
Programming the Status Register System
Status Groups
Baseband Operation Status Group
NOTE This status group does not apply to the E4428C, E8257D, E8663B, and the E8663D, and if
queried, returns zero. See Table 4-8 on page 188 for more information.
This status group does not apply to the N5161A/62A/81A/82A/83A. (If queried, the signal
generator will not respond.)
The Baseband Operation Status Group is used to determine the specific event that set bit 10 in the
Standard Operation Status Group. This group consists of the Baseband Operation Condition Register, the
Baseband Operation Transition Filters (negative and positive), the Baseband Operation Event Register, and
the Baseband Operation Event Enable Register.
This is the named
status register for
the E4438C.
However, not all
signal generator
models use all of
the shown events
(i.e. some use only
a subset of the
E4438C’s status
registers).
To Next Page
Loading...
Need help?
General
