Keysight Signal Generators Programming Guide 337
Creating and Downloading User–Data Files
User File Data (Bit/Binary) Downloads (E4438C and E8267D)
After execution of this command, the signal generator creates a file in the Binary (Bin) directory
(memory catalog) named “new_file” that contains 34 bytes.
For information on downloading block data, see “Downloading User Files” on page 332.
Selecting a Downloaded User File as the Data Source
This section describes how to format SCPI commands for selecting a user file using commands from
the GSM and Custom modulation formats. While the commands shown come from only two formats,
the concept remains the same when making the data selection for any of the other real–time
modulation formats that accept user data. To find the data selection commands for both framed and
unframed data for the different modulation formats, see the signal generator’s SCPI Command
Reference.
1. For TDMA formats, select either framed or unframed data:
:RADio:GSM:BURSt ON|OFF|1|0
ON(1) = framed OFF(0) = unframed
To Next Page
Loading...
