Keysight E4428C ESG RF - Data Questionable BERT Status Group

Keysight Signal Generators Programming Guide 209
Programming the Status Register System
Status Groups
Data Questionable BERT Status Group
NOTE This status group applies only to the E4438C with Option UN7. Refer to Table 4-18 on
page 210 for more information.
The Data Questionable BERT Status Group is used to determine the specific event that set bit 12 in
the Data Questionable Condition Register. The Data Questionable Status group consists of the Data
Questionable BERT Condition Register, the Data Questionable BERT Transition Filters (negative and positive),
the Data Questionable BERT Event Register, and the Data Questionable BERT Event Enable Register.