Chapter 6: Replacing Assemblies
To remove and replace the PCI bridge board
118
4
Remove the Torx T10 screw that secures the PCI bridge board to the rear of
the chassis.
5 Pull the board up to disengage it from the motherboard, then lift it up and out
of the chassis.
6 To replace the board, reverse the removal procedure.
Figure 6-24
Removing the PC interface and GPIB board
Acquisition
board cable
T10 Torx Screw
PCI bridge
board
Keyboard cable
Motherboard
standby cable
Power supply
standby cable
To Next Page
Loading...
