Keysight Infiniium 8000 Series - Replacing Assemblies

6
ESD Precautions 96
Tools Required 96
To return the oscilloscope to Keysight Technologies for service 97
To remove and replace the top cover 98
To remove and replace the bottom sleeve 99
To disconnect and connect Mylar flex cables 101
To remove and replace the CD- ROM drive 102
To remove and replace the AutoProbe assembly 104
To remove and replace the internal digital input cable (MSO models only) 106
To remove and replace the backlight inverter board 107
To remove and replace the front panel assembly 108
To remove and replace the keyboard, touch screen, and flat- panel display assemblies 113
To remove and replace the acquisition board assembly 116
To remove and replace the PCI bridge board 117
To remove and replace the display board 119
To remove and replace the hard disk drive 120
To remove and replace the motherboard 122
To replace the Intel motherboard with the ADLINK motherboard 124
To remove and replace the power supply 131
To remove and replace the fan controller board 134
To remove and replace a fan 135
To remove and replace the probe power and control assembly 136
Replacing Assemblies