26 Keysight Infiniium S-Series Oscilloscopes User’s Guide
2 Using the Oscilloscope
Learning the Front Panel Connectors
On the Infiniium S-Series oscilloscopes, the channel inputs, digital channels
connector, probe compensation terminal, and ground plug appear on the lower
part of the front panel. Two USB 2.0 host ports are also located here.
Channel inputs
Your Infiniium oscilloscope comes with four 10:1 500 MHz passive probes.
The AutoProbe interface works with the InfiniiMax III probing system. See
“Connecting Oscilloscope Probes" on page 17.
For the latest information about probes for your Infiniium oscilloscope, install the
Probe Resource Center. Instructions for downloading are in the online Help
described in Chapter 3, “Online Help and Other Information”.
Digital channels connector
MSO models include a 17-channel flying lead set logic probe, an MSO cable, and a
calibration fixture.
Probe compensation terminal
This terminal has a square wave signal that is used to adjust compensated passive
probes.
You can also output a DC level on this terminal using the Infiniium oscilloscope
application's Calibration Output dialog box (Utilities > Calibration Output...).
Ground
The ground plug is convenient for ESD wrist straps.
Figure 7 Front panel connectors
DIGITAL D15-D0
1
2
3
4
All Inputs
1M Ω ±40V MAX
50
5V MAX
1M
~
~
14pF
Probe Comp
+
To Next Page
Loading...
Need help?
General
