Need help?Do you have a question about the Keysight N5186A and is the answer not in the manual?
Provides a general introduction to the Keysight N5186A MXG signal generator.
Details the physical connections between the MXG and the signal analyzer.
Configures the trigger source and level for signal acquisition.
Covers procedures for basic signal generation, modulation, and analysis.
Explains removing test fixture and cabling effects using software.
Describes how to add s2p files to correct amplitude and phase.
Details steps to measure corrections using a spectrum analyzer.
Outlines the procedure for making corrections with a power meter.
Covers 5G testing, observing EVM and ACP using analyzer, including trigger setup.
Step-by-step guide to measure EVM for 1 CC 3.5 GHz signals.
Procedure for setting up and measuring ACP for 1 CC 3.5 GHz signals.
Guide to creating and analyzing waveforms using PathWave software and auto-configuring the analyzer.
Provides a general introduction to the Keysight N5186A MXG signal generator.
Details the physical connections between the MXG and the signal analyzer.
Configures the trigger source and level for signal acquisition.
Covers procedures for basic signal generation, modulation, and analysis.
Explains removing test fixture and cabling effects using software.
Describes how to add s2p files to correct amplitude and phase.
Details steps to measure corrections using a spectrum analyzer.
Outlines the procedure for making corrections with a power meter.
Covers 5G testing, observing EVM and ACP using analyzer, including trigger setup.
Step-by-step guide to measure EVM for 1 CC 3.5 GHz signals.
Procedure for setting up and measuring ACP for 1 CC 3.5 GHz signals.
Guide to creating and analyzing waveforms using PathWave software and auto-configuring the analyzer.
General| Brand | Keysight |
|---|---|
| Model | N5186A |
| Category | Signal Processors |
| Language | English |
To Next Page