Keysight N5186A - Basic Measurements

7
N5186A MXG Signal Generator and X-Series Signal Analyzer
Measurement Guide
1 Basic Measurements
— “Equipment Setup” on page 9
— “Setting Up Triggers on the Signal Analyzer” on page 10
— “Making Measurements” on page 11
— “Creating a Continuous Waveform (CW)” on page 11
— “Setting Up Amplitude Modulation” on page 16
— “Setting Up Frequency Modulation” on page 21
— “Setting Up Phase Modulation” on page 25
— “Setting Up a Multitone Signal” on page 29
— “Setting Up Waveform File Vector Modulation” on page 33