Keysight N5186A - Page 57

N5186A MXG and X-Series SA Measurement Guide 57
Corrections
Corrections/De-embedding Using PathWave E7653APPC Software
CORRection ON
Adding fixture blocks using s2P files
On the MXG:
SYSTem:PRESet
RF1:FREQuency:CW 3GHZ
RF1:POWer:AMPLitude -20dBm
SIGNal1:MODE MTONe
SIGNal1:MTONe:ARB:NTON 21
SIGNal1:MTONe:ARB:FSP 100MHZ
SIGNal1 ON
RF1:OUTPut:STATe ON
For multi-channel instruments, set RF Out (all) to On.
RFALl:OUTPut ON
On the X-Series Signal Analyzer:
SYSTem:PRESet
FREQuency:CENTer 3GHZ
FREQuency:SPAN 1GHZ
On the MXG:
Set the path to the s2p data as block 2 (you can use 1 through 4).
CORRection:BLOCk2:FILE "FixtureChannel2"
CORRection:BLOCk2 ON
Add block C with the same file.
CORRection:BLOCk3:FILE "FixtureChannel2"
Change Block C to Embed.
CORRection:BLOCk3:APPLy EMBedding
CORRection:BLOCk3 ON