Keysight N6701C - Page 283

l This command has been superceded by the SENSe:FUNCtion:CURRent and SENSe:FUNC-
tion:VOLTage commands, which should be used in new applications. SENSe:FUNCtion is still avail-
able for backward compatibility.
SENSe:FUNCtion:CURRent 0|OFF|1|ON, (@<chanlist>)
SENSe:FUNCtion:CURRent? (@<chanlist>)
SENSe:FUNCtion:VOLTage 0|OFF|1|ON, (@<chanlist>)
SENSe:FUNCtion:VOLTage? (@<chanlist>)
Enables or disables the current or voltage measurement function.
Parameter Typical Return
0|OFF|1|ON,
*RST current OFF; voltage ON
0or1
Enables current measurements: SENS:FUNC:CURR ON, (@1)
Enables voltage measurements: SENS:FUNC:VOLTON, (@1)
l These commands replace the previous SENSe:FUNCtion command and should be used in new
applications. SENSe:FUNCtion is still available for backward compatibility.
SENSe:FUNCtion:VOLTage:INPut MAIN|AUXiliary, (@<chanlist>)
SENSe:FUNCtion:VOLTage:INPut? (@<chanlist>)
Selects the voltage measurement input.
MAIN - selects the front panel binding posts as the measurement inputs.
AUXiliary - selects the rear panel auxiliary voltage inputs as the measurement inputs.
Parameter Typical Return
MAIN|AUXiliary, *RST MAIN MAIN or AUX
Selects the auxiliary voltage input: SENS:FUNC:VOLT:INP AUX, (@1)
SENSe:SWEep:OFFSet:POINts <value>, (@<chanlist>)
SENSe:SWEep:OFFSet:POINts? [MIN|MAX,] (@<chanlist>)
Defines the offset in a data sweep for triggered measurements. Positive values represent the delay
after the trigger occurs but before the samples are acquired. Negative values represent data samples
taken prior to the trigger.
Parameter Typical Return
–524,287 to 2,000,000,000|MIN|MAX, *RST 0 <offsetpoints>
Specifies -2048 offsetpoints: SENS:SWE:OFFS:POIN -2048, (@1)
Keysight N6700C Operating and Service Guide 283
5 SCPI Programming Reference