Keysight N9041B - 7.2.39 Data Segment Index; 7.2.40 Data Type; 7.2.41 CC Setup

7 Save/Recall/Print
7.2 Recall
Studio N7608C:
Custom Modulation = Custom IQ
Custom IQ Type = ASK&PSK&QAM, FSK, SOQPSK
Note: some Custom IQ Type + Filter combination is not supported yet and will cause recall error too
Couplings When "Data Segment Index" on page 2342 is 0, SEGMent in SCPI and Select Seg on GUI are ignored
and up to 6 segments in file will be recalled and applied
7.2.39 Data Segment Index
Selects a data segment defined in a Carrier Setting file to recall, segment x in file is
recalled and applied to segement y ("Select Segment" on page 2338) in Digital
Demod measurement. When x is 0, y is ignored and up to 6 segments in file are
recalled and applied. Note "Select Segment" on page 2338 is GUI-only, so y needs
to be specified in "Carrier Setting" on page 2341 SCPI.
Remote
Command
:MMEMory:LOAD:DDEMod:INDex:SEGMent <int>
:MMEMory:LOAD:DDEMod:INDex:SEGMent?
Example
:MMEM:LOAD:DDEM:IND:SEGM
:MMEM:LOAD:DDEM:IND:SEGM?
Preset 0
State Saved No
Min 0
Max 100
7.2.40 Data Type
There are several Demod Info Data Types available. You can specify to which
component carrier you want to recall the Demod Info and also choose which data
type you want to recall.
7.2.41 CC Setup
Selects a file from which to import the component carrier setup and demod settings
to all component carrier or specified component carrier.
The following file formats are supported:
Format Extension Notes
xSA Setup Files
.xml
Export from Signal Studio N7608C
89601 VSA Setup Files
.set, .setx
Signal Studio N7608C Setup Files
.scp
2342 Vector Modulation Analyzer Mode User's &Programmer's Reference