Keysight N9041B - Meas Time; Sample Rate

3 VMA Mode
3.4 IQ Waveform Measurement
Auto Function
Remote
Command
[:SENSe]:WAVeform:AVERage:TACount:AUTO OFF | ON | 0 | 1
[:SENSe]:WAVeform:AVERage:TACount:AUTO?
Example
:WAV:AVER:TAC:AUTO ON
:WAV:AVER:TAC:AUTO?
Preset
ON
Range
Auto|Man
Meas Time
Lets you set how long the measurement is performed. X Scale only changes the
scale of the display.
Remote
Command
[:SENSe]:WAVeform:SWEep:TIME <time>
[:SENSe]:WAVeform:SWEep:TIME?
Example
:WAV:SWE:TIME 50 ms
:WAV:SWE:TIME?
Notes Specifies and returns how long the measurement is performed. It is the time record length of the
measurement waveform. The Max time may be reduced when the sample frequency is high due to the
memory limitation
Preset LTE, LTETDD, LTEAFDD, LTEATDD, 5G NR Modes: 10 ms
All other Modes: 2.000000 ms
State Saved Saved in instrument state
Range 1.000 us to 100.00 s
Min/Max 1.000 us/100.0 s
1.000 us/3200 s
Sample Rate
Sets an arbitrary sample rate for the acquired data to be processed.
Remote Command
[:SENSe]:WAVeform:SRATe <freq>
[:SENSe]:WAVeform:SRATe?
Example
:WAV:SRAT 1.3636 MHz
Notes The command and query are available when Option DP2, B40, or wider IF Bandwidth option is
installed. For other configurations, only the query is available
Dependencies To set a 2.4 GHz Sample Rate with Options R15 or R20, Center Frequency must be greater than or
equal to 3.5 GHz
To set a 5.1 GHz Sample Rate with Option R40, Center Frequency must be greater than or equal to 10
GHz
Vector Modulation Analyzer Mode User's &Programmer's Reference 760