Keysight N9041B - 7.2.50 Channel; 7.2.51 Reset

7 Save/Recall/Print
7.2 Recall
7.2.50 Channel
Select data channels to recall. This is only supported in the 5GNR EVM, VMA Digital
Demod, VMA Custom OFDM and WLAN MIMO EVM measurements.
The <meas> param in the command must be replaced with the node of the active
measurement:
–
EVM for 5GNR EVM
–
EVMM for WLAN MIMO EVM
–
DDEM for VMA Digital Demod
–
OFDM for VMA Custom OFDM
Remote
Command
:MMEMory:LOAD:<meas>:RECording:CHANnel ALL | CH1 | CH2 | CH3 | CH4 | CH5 |
CH6 | CH7 | CH8
:MMEMory:LOAD:<meas>:RECording:CHANnel?
Example
:MMEM:LOAD:EVM:REC:CHAN CH1
:MMEM:LOAD:EVM:REC:CHAN?
Preset
ALL
State Saved No
Range
ALL|CH1|CH2|CH3|CH4|CH5|CH6|CH7|CH8
7.2.51 Reset
Clears all recalled data channels.
This is only supported by 5GNR EVM, VMA Digital Demod, VMA Custom OFDM and
WLAN MIMO EVM measurements.
The <meas> param in the command must be replaced with the node of the active
measurement:
–
EVM for 5GNR EVM
–
EVMM for WLAN MIMO EVM
–
DDEM for VMA Digital Demod
–
OFDM for VMA Custom OFDM
Remote
Command
:MMEMory:LOAD:<meas>:RECording:RESet
Vector Modulation Analyzer Mode User's &Programmer's Reference 2347