6-30 TOS5051A/5050A
6.5.3 MOMENTARY Switch
If you set this switch to ON, the test is executed only during the period you keep
pressed the START switch. As you release the switch, the test terminates. Thus, the
safety of test is enhanced.
This function is applicable also when in the
remote control mode. If you use this function
together with the both-hand type remote con-
trol box (RC02-TOS), the safety of test is
enhanced still more.
6.5.4 FAIL MODE Switch
If you set this switch to ON, the tester cannot be reset from the FAIL judgment or
PROTECTION status with the STOP signal applied from the remote control circuit.
To reset the tester, you need to press the STOP switch.
You may use this function in order to be sure
of the FAIL status or PROTECTION status
when you are making tests with the optional
HV test probe (HP01A-TOS or HP02A-TOS).
DOUBLE ACTION
PASS HOLD
MOMENTARY
FAIL MODE
OFF ON
Fig. 6-13 Setting momentary
DOUBLE ACTION
PASS HOLD
MOMENTARY
FAIL MODE
OFF ON
Fig. 6-14 Setting FAIL mode
To Next Page
Loading...
