Kikusui TOS5050A - 7.6 RS-232 C Commands and Responses; 7.7 Sample Program

TOS5051A/5050A 7-7
Chap.7
RS-232C Interface
7.6 RS-232C Commands and Responses
This section describes the commands that the tester supports one by one.
• Commands are not case-sensitive. Responses are returned in upper-case.
• The response for command error is ERROR.
• The command inside the parentheses is the abbreviated form of the command.
*IDN?
Queries the model name and ROM version of the tester.
Response
Returned as in the example below.
Fig. 7-2 Response example of *IDN?
*RST
Resets the tester (the talk mode is set to default (0) in this version).
Response
Returns OK.
• The talk mode setting specified by a command is reset to the panel setting when
the tester is power cycled.
STATUS? (STAT?)
Queries the tester status.
Response
Returns any of the following:
PROTECTION, TEST, READY, PASS, U_FAIL, L_FAIL, or ELSE
(ELSE indicates a status other than PROTECTION, TEST, READY, PASS,
U_FAIL, or L_FAIL.)
KIKUSUI ELECTRONICS CORP.,TOS5051A,0,1.00
Company name Model name Version numbe
r
Not used
Comma separator
NOTE