Kimo CPE 300 - Alarm; Relay Settings • F400; A - Activation; Deactivation of BEEP Alarm; B - Relay Security

7. Alarm / relay settings
7.a - Activation / Deactivation of BEEP alarm
Go into configuration mode (page 5). The folder number displayed corresponds to
the last configuration folder used.
Select the folder “400” and validate with .
Select sub-folder “400” and validate with .
The cursor > goes to available choices.
With and keys, select 01 to activate the BEEP alarm or 00 to
deactivate. Validate with .
The cursor > goes to sub-folders line.
• press twice to return to reading mode.
• press once to return to another folder selection.
• with and keys you can choose another sub-folder from the folder 400.
7.b - Relay security
Enter in configuration mode (see page 5). The folder number displayed
corresponds to the last configuration folder used.
Select folder “400” and validate with .
Select sub-folder “401” and validate with .
The cursor > goes to available choices.
With the keys and , select 01 for a positive security or 00 for a
negative security. Validate with .
The cursor > returns to sub-folders line.
• press twice on to return to reading mode.
• press once on to return to another folder selection.
• with and keys, you can choose another sub-folder from the folder 400.
The relay outputs are by default, in negative security: the relay is energized when a set point is reached.With
the remote control, you can swap the relays in positive security : then, the relay is de-energized when a set
point is reached or during a power outage.
The beep alarm (audible alarm) is activated when a set point is reached.
For more details on the setpoint settings, see page 20.
d
b
u
o
s
M
800
d
b
u
o
s
M
802
Page 12
1
Step
2
Step
3
Step
4
Step
1
Step
2
Step
3
Step
4
Step
CPE 300 transmitter configuration via remote control / Modbus