E3 : this screen reminds the general format of the session of measurement:
• Start : date of measurement start
• End : date of measurement end (here, not entered because measurement is still ongoing).
• Time : measurement time (here, not entered because measurement is still ongoing).
• Mode : measurement mode type (here, L-Stock)
• Weig. : weighting frequency type (here, A)
• Cst : time weighting (here, F)
• Lpk : weighting frequency type of the peak sound level (here, C)
• Samp. : sampling rate (here, 01s)
5.2.4 Stop the measurement
We stopped the measurement manually through the pictogram.
Note : The manual command (Start - Stop) has priority over the I/O command (even if the initial choice is a start from the I/O
command).
The pause function is inoperative.
5.2.5 Store data
At the end of the measurement, in manual mode, a screen of all results is displayed. It is then possible to :
➢ Accept measurements and store them : move the cursor on Sto. and press once on OK key to confirm. A banner displays the
storage phase.
➢ Reject measurements and not store them : move the cursor on RST and press twice on OK key to confirm. A banner displays
the phase of suppression of data.
Make some measurements 12
Screen 3
Ongoing
measurement
Results
Storage
Results
Deletion
Ongoing
measurement
RST active
To Next Page
Loading...
