➢ Press OK key to access to E1 main screen results.
• LUpk : level of maximum peak of sound pressure on the measurement time.
• LXeqM : maximum value of equivalent continuous sound pressure level of all elementary integration times.
• LXeqm : minimum value of equivalent continuous sound pressure level of all elementary integration times.
• LXeq : equivalent continuous level of sound pressure on the overall measurement time.
• LXE : level of exposure to sound frequency weighted.
• D : measurement time in DD/HH:MM:SS
• % : percentage of saturation of the input stage.
• Statistical indices : L01 – L10 – L50 – L90 – L95. They are calculated from stored samples.
➢ With scrolling knob key, go to E2 screen which reminds measurement configuration.
• Date of measurement start
• Date of measurement end
• Measurement time expressed in DD / HH: MM: SS.
• Measurement mode : Leq-St
• Frequency weighting for Leq : Weig.
• Elementary integration time for Leq : DI
• Frequency weighting of the level of peak pressure for L : LpK
➢ Press Esc key to quit this file and back to file selection main screen.
6.2.4 S1+S2 mode file
When the file has been identified by its identification number, you access to the main single screen of results.
It shows :
• S1 + S2 : equivalent continuous level of both sources
• S2 : equivalent continuous level of S2 sound source
• S1 : equivalent continuous level of S1 sound source
• Frequency weighting of the equivalent continuous level
• Measurement time for the calculation of equivalent
continuous level
• Press Esc key to quit this file and back to file selection main
screen.
23 Read the stored files
Stored file
E1 screen E2 screen Stored file
To Next Page
Loading...
