E3 : this screen reminds the general format of the session of measurement:
• Date of measurement start
• Date of measurement end : not entered because measurement is still ongoing.
• Measurement time : not entered because measurement is still ongoing.
• Measurement mode : L-Leq
• Frequency weighting for L and Leq : Weig.
• Time weighting for L : Cst
• Integration time for Leq : S/S (Start/ Stop mode)
• Frequency weighting of the level of pressure peak for L : Lpk
5.3.4 Stop the measurement
We stopped the measurement manually through the pictogram.
Note : The manual command (Start - Stop) has priority over the I/O command (even if the initial choice is a start from the I/O
command).
The pause function is inoperative.
5.3.5 Store data
At the end of the measurement, in manual mode, a screen of all results is displayed. It is then possible to :
➢ Accept measurements and store them : move the cursor on Sto. and press once on OK key to confirm. A banner displays the
storage phase.
➢ Reject measurements and not store them : move the cursor on RST and press twice on OK key to confirm. A banner displays
the phase of suppression of data.
Make some measurements 14
Screen 3
Ongoing
measurement
Results
Storage
Ongoing
measurement
Results RST active
Deletion
To Next Page
Loading...
