Kinetec Spectra - Defining Patient Tolerance - During Session; Selecting the BY-PASS Mode; Setting New Pain Level During Session

1717
GB
Use of the hand controlUse of the hand control
How to define the patient tolerance • During the sessionHow to define the patient tolerance • During the session
This function, The BY-PASS MODE is a way to address the pain threshold of a patient during a session.
IMPORTANT: Can be used only when the machine RUN.IMPORTANT: Can be used only when the machine RUN.
Beginning Keys to press Display Remarks
The unit is running
Or
Check if the hand control is not blocked
(See page 7).
To select the BYPASS mode
The display indicates the keys used to run the
machine.
This message is displayed 3 seconds.
To select the NEW pain level or
The unit is moving to the selected way.
It is waiting for you to select new limits.
To set the NEW pain level when reached, immediately
press
or The new limit of the movement is recorded.
Continue the session with the new movement limits.
The angle display changes with current
movement.
Kinetec
30 RUN 15 90
WARMUP
30 RUN 15 90
PYPASS: use + or -
30 RUN 15 90
BYPASS: use + or -
30bypass 100 90
bypass.: use + or -
30manual 50 50
WARMUP
30 run 45 50