Technical manual
ATTENTION: Make sure to properly dispose of any
plastic bags, keeping them out of the reach of
children as they can be dangerous for them.
Inside you will find: The water treatment equipment,
installation accessories and its documentation.
The materials used in the packaging are recyclable and
must be discarded in the appropriate collection bins or
in the local center designated for the recuperation of
waste materials.
This product cannot be discarded together with other
urban waste. When the equipment’s lifespan comes to
an end, it should be handed over to the company or
center where you acquired the device, or in a Recy-
cling Center or local center specialized in the recycling
of materials, indicating that it has electronic compo-
nents and refrigerating gases. The proper collection
and treatment of unusable devices contributes to the
preservations of natural resources and helps avoid any
potential risks to public health.
4. INSTALL ATION
ATTENTION: Before disassembling the
equipment, anticipate all the mate-
rial you will need to perform mainte-
nance operations (read section 5 Installa-
tion) and the space required for it. Work in
a properly lit place, in adequate hygienic
conditions and with enough space to per-
form operations comfortably.
The installation of your osmosis equipment must be carried
out by qualified personnel sufficient for this. Read this ma-
nual beforehand and consult the dealer in case of doubt.
ATTENTION: Since the device to be installed im-
proves the quality of the water to be consumed,
all the tools that are going to be used for assembly
and installation must be clean and in no case can they
be contaminated or impregnated with grease, oils or
oxides Use tools exclusively for tube cutting, membra-
ne manipulation, etc. Keep them clean and disinfect
them periodically.
ATTENTION: The work must be carried out with
an appropriate attitude and hygienic conditions,
taking precautions in everything related to mate-
rials and components that will be in contact with the
water to be treated or consumed.
(For more information contact your distributor).
ATTENTION: Avoid the risks of external contami-
nation of the equipment by improper handling,
using gloves, hand sanitizing gel or washing your
hands as many times as necessary throughout the
installation, commissioning and maintenance of the
equipment.
5
6
7
ATTENTION: Some of the installation’s accessories may
vary depending on the model and the region in which
the equipment is distributed.
4.1. MIXING KIT
• If you want to increase the pH, conductivity and concen-
tration of chlorine at the outlet, you must perform the insta-
llation according to the following scheme and using the co-
rresponding components included in the mixing kit (consult
your dealer).
6.1
6 mm
Clamp for 40 mm drain.
Adapter and input
stopcock for 3/8 ”con-
nections.
See hydraulic diagram on page 13.
The most frequent place for the installation of the equi-
pment is usually under the kitchen sink or in an atta-
ched furniture.
Install the faucet, hydraulically and electrically, to the
equipment drain hose and inlet adapter and connect
them to the respective equipment connectors (5, 6, 6.1
and 7).
To Next Page
Loading...
