Kinetico K10 User Manual

7
7. IDENTIFICATION AND RESOLUTION OF PROBLEMS
Multiple possible causes.
1. There is no supply of water.
2. There is no power supply.
3. Leakage sensor is activated.
1. Power key is partially closed.
2. Filters/Membrane are in poor
condition or worn out.
Multiple possible causes.
Multiple possible causes.
Air in the system. Microbubbles of
air that disappear after some se-
conds.
Multiple possible causes.
1. There is no supply of water.
2. There is no power supply.
3. Leakage sensor is activated.
Multiple possible causes.
1. Intake electrovalve has deteriorated.
2. Production anti-drain has deterio-
rated.
Call the technical service.
1. Wait for the supply to come back.
2. Check the power supply of your residence.
If you don’t solve the problem, call the tech-
nical service.
3. Leakage sensor is activated. If you don’t no-
tice any leakage, remove the lower part of the
equipment together with the leakage sensor.
If this happens again, call technical service.
1. Open it fully.
2. Call technical service.
Call technical service.
Call technical service.
This does not represent any problems. The
colour will come to disappear if you elimina-
te the air inside the equipment.
Call technical service.
1. Wait for the supply to come back.
2. Check the power supply of your residen-
ce. If you don’t solve the problem, call the
technical service.
3. Leakage sensor is activated. If you don’t no-
tice any leakage, remove the lower part of the
equipment together with the leakage sensor.
If this happens again, call technical service.
Call technical service.
1. Check and replace.
2. Check and replace.
1. External leakage.
2. No water is pro-
duced.
3. Low production.
4. Excessive produc-
tion.
5. Unpleasant taste or
smell.
6. Water has an
off-white colour.
7. Dripping noises
heard in the drain.
8. The equipment
won’t start.
9. The equipment
stops and restarts
continuously.
10. The equipment
never stops rejecting
water to the drain.
PROBLEM
POSSIBLE CAUSE SOLUTION
Read the INTERFACE section of the Technical Sheet. In the event of anomaly get in touch with the TAS and proceed
as follows: Close the input key. Open the tap to depressureize the sytem and disconnect the plug.
Closed
Abrir
Open

Kinetico K10 Specifications

General

Brand	Kinetico
Model	K10
Category	Water Filtration Systems
Language	English