Kinetico K5 - Page 17

K5 Drinking Water Station
Revised: 09/2016 Drinking Water Systems Section 7
Page 17
⅜” plug
11. Remove cartridge plug
12. Pour one package of
cleaning agent into dry
cartridge – install plug
into cartridge prefilter
position.
13. Install RO membrane
WARNING: handle plug with care when
removing. May contain chemical solution.
14. Remove ⅜” plug from
yellow port on manifold
and insert ⅜” tube into
same yellow port.
15. Slowly open feed valve
17. Open jack screw
completely
Place the other end into a 5 gallon
bucket.
16. Wait 2 minutes
Note: You may hear a
buzzing sound from the
unit. This is normal for
start-up. Check for leaks.
18. Fill bucket
19. Close feed
20. Close jack screw
Cleaning Agent
chlorine dioxide tablet
(crush tablet while still in packet) or granules
WARNING: Do not overflow.
Note: Do not over tighten.
prefilter position