K5 Drinking Water Station
Section 7 Drinking Water Systems Revised: 09/2016
Page 32
23. Turn jack screw completely.
Hold onto line while bucket fills.
Warning: Do not overflow.
26. Turn jack screw
completely (clockwise).
27. Remove ā
ā line and replace
plug in yellow port.
Note: Do not over tighten.
28. Discard water in bucket.
29. Open tank ball valve.
30. Wait for flow to drop off.
Close feed and allow system to depressurize.
Leave faucet open
31. Remove prefilter, postfilter
and auxiliary cartridge
plugs (as necessary).
34. Wait for steady permeate
flow at the faucet, then
close the faucet. Remove
anti-spray line.
32. Install all remaining
cartridges.(Auxiliary
cartridges must already be
prepped according to their
installation instructions.)
35. Inform customer to
discard first two tanks
of water.
To Next Page
Loading...
