Kinetico K5 - Page 35

K5 Drinking Water Station
Revised: 09/2016 Drinking Water Systems Section 7
Page 35
22. Remove sanitization
cartridge.
23. Add 5 mL unscented bleach to a sanitization cartridge that
is half full of clean water.
WARNING: Handle plug
with care when removing.
May contain chemical
solution.
Install in prefilter position.
24. Install RO.
25. Turn jack screw
completely.
26. Slowly open feed valve.
(counterclockwise)
27. Wait for flow to drop off.
28.
Remove prefilter sanitization
cartridge and cartridge plugs
(as necessary).
29.
Install all remaining
cartridges.(Auxiliary cartridges
must already be prepped
according to their installation
instructions).
Close feed and allow system to depressurize.
Leave faucet open.
)
30. Slowly open feed valve
31.
Wait for steady permeate flow
at the faucet, then close
faucet. Remove
anti-spray line.
32.
Inform customer to discard
first two tanks of water.