K5 Drinking Water Station
Revised: 09/2016 Drinking Water Systems Section 7
Page 41
15. Turn jack screw completely (clockwise).
16. Slowly open the supply valve and allow the
storage tank to fill.
Note: Do not over tighten.
(This will take approximately four minutes and you may hear buzzing
during this step. This is normal.)
17. Close storage tank valve.
19. Turn jack screw completely
(counterclockwise), wait one minute then
turn jack screw completely (clockwise).
20. Close the supply valve and allow the
system to depressurize. Leave the faucet
open.
Note: Do not
over tighten.
21. Disconnect the tubing from the supply valve and shake out any excess water. Add 5 mL of
solution in the end of the tube, then re-attach to the supply valve.
To Next Page
Loading...
