King-Meter Digital II - PAS Sensor Setting

Depen
ding on the hardware of the controller, the co
8.5 PAS sensor setting
8.5.1 PAS sensor direction setting
Run stands for PAS sensor direction setting.
stands for reverse. Switch between
【
setting of PAS
sensor, the factory default value of the meter is positiv
8.5.2 PAS Sensor Sensitivity Setting
SC
N is indicated on the screen, which r
them, 2 means the highest sensitivity, 9 means the lowest sensitivity. Set by
【MODE】 to confirm
and enter PAS sensor ratio setting interface
8.5.3
PAS Sensor Ratio Parameter Setting.
N-
stands for PAS sensor ratio parameter. Select PAS sensor parameter through
the value, the more obvious the assist feeling. Long
personalized setting interface.
KING-
METER TECHNOLOGY
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：
+0086 022 8478 0358
13
ding on the hardware of the controller, the co
ntroller may not reach the set 18A
Run stands for PAS sensor direction setting.
Run-F/b is indicated on the screen. run-
F stands for forward and run
【
UP】 and 【DOWN】, short press【MODE】
to confirm, enter the sensitivity
sensor, the factory default value of the meter is positiv
e.
N is indicated on the screen, which r
epresents the sensitivity of PAS sensor. The setting range is 2
them, 2 means the highest sensitivity, 9 means the lowest sensitivity. Set by
【UP】
and
and enter PAS sensor ratio setting interface
. The default
value is 2.
PAS Sensor Ratio Parameter Setting.
stands for PAS sensor ratio parameter. Select PAS sensor parameter through
【UP】
and
the value, the more obvious the assist feeling. Long
press 【MODE】to confirm
and return to the d
METER TECHNOLOGY
CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
+0086 022 8478 0358
Tel: +0086 022 8478
F stands for forward and run
-b
to confirm, enter the sensitivity
epresents the sensitivity of PAS sensor. The setting range is 2
-9. Among
and
【DOWN】, short press
value is 2.
and
【DOWN】. The larger
and return to the d
isplay