5.4 Walk Assist
After press 【DOWN】 >2s,the e-
uniform speed of 6 Km/h. 6KM flashe
“Walk Assist
” function can only be used
when riding.
5.5
Turn on/off the backlight
Long press 【UP】 >2s,
is insufficient, the LCD backlight can be turned on.
5.6 PAS Level setting
Short press 【UP】 or 【DOWN】
power of the display: 1-5,
The default level when the display is turned on is l level.
5.7 Battery indication
When the battery voltage is high, the five
the battery flashes, indicating that the battery is seriously undervoltage and needs to be charged immediately.
KING-
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax:
7
enters the mode of power walk assist state
” function can only be used
as pushing the e-
bike by hands. Please don’t use
Turn on/off the backlight
turned on,and turn on the headlight of
is insufficient, the LCD backlight can be turned on.
Press 【UP】 again>2s,the LCD
to switch the PAS level and c
hange the motor output power. Default
The default level when the display is turned on is l level.
When the battery voltage is high, the five
-segment LCD is on. Wh
en the battery is undervoltage, the outer frame of
the battery flashes, indicating that the battery is seriously undervoltage and needs to be charged immediately.
CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Tel: +0086 022 8478
-bike will go on at a
bike by hands. Please don’t use
this function
When the external light
turned off.
hange the motor output power. Default
output
en the battery is undervoltage, the outer frame of
the battery flashes, indicating that the battery is seriously undervoltage and needs to be charged immediately.