6. Error code
When the e-
bike electronic control system fails, the dis
definition of detailed error codes, see appendix 1.
The fault can only be exited when the fault is eliminated, and the e
fault occurs.
7. User setting
7.1 Prepar
Ensure that the connectors are firmly connected and turn on the power of the e
7.2 General setting
Long press 【MODE】
to turn on. When the display is turned on, press
2s, interface will enter the
7.2.1 Reset trip distance.
TC
stands for resetting the trip distance, setting the parameters can be N/Y. The default N means not to reset the
trip distance. Press 【UP】/【DOWN
the trip distance is not need to reset.
Trip distance and single riding time will be reset at the same time.
KING-
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：
8
Low Voltage Flash
bike electronic control system fails, the dis
play will automatically indicate the
definition of detailed error codes, see appendix 1.
The fault can only be exited when the fault is eliminated, and the e
-
bike cannot continue to drive after a
Ensure that the connectors are firmly connected and turn on the power of the e
-bike.
to turn on. When the display is turned on, press
【UP】and【
stands for resetting the trip distance, setting the parameters can be N/Y. The default N means not to reset the
to select Y/N, Y means that the trip distance is need to reset.
the trip distance is not need to reset.
Trip distance and single riding time will be reset at the same time.
CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Tel: +0086 022 8478
play will automatically indicate the
error code. For the
bike cannot continue to drive after a
】at the same time for
stands for resetting the trip distance, setting the parameters can be N/Y. The default N means not to reset the
to select Y/N, Y means that the trip distance is need to reset.
N means that
To Next Page
Loading...
Need help?
General
