Kipor IG1000 - Output and Overload Indicators Explained

3.2 Hard Starting Continued
14
Measure the spark plug gap and
perform the spark plug test. Gap:
024-028 in
(
0.6—0.7mm
)
Perform the spark test again using a
new spark plug
Good spark
Replace the spark plug
No spark
No spark
Check the trigger
Abnormal
Replace the trigger or readjust
trigger clearance
Check the ignition coil resistance
and high pressure cable, high
pressure insulation cap.
Inspection or replace wire harness.
Abnormal
Replace the ignition coil
Normal
Check the resistance of motor
ignition winding
Replace the motor stator
Abnormal
Replace the engine switch
No spark
Check the engine switch
Good spark
Replace the low oil alarm
Disconnect the low oil alarm and
perform spark test
Good spark
No spark
Remove the control panel. Perform
spark test with a new ignition module.
Good spark
Replace the ignition module
No spark
Normal
Normal
© 2011 Kipor Power Systems, Inc.