4) Measure the plug gap with a wire-type feeler gauge. Adjust by bending the side electrode if the
measure is not accord with the asked valve.
Spark plug clearance .024-.028 in. (0.6~0.7mm)
Standard spark plug UR5
0.6-0.7
5). Install the plug finger tight to seat the washer, and then tighten with a plug wrench.
Torque valve is 8.-~9.6 ft lbs, 11~13 N.m
4.6 Valve clearance
Caution
■ Valve clearance inspection and adjustment must be performed with the engine cold.
Inspection/Adjustment:
1) Remove the following parts:
―Front cover, control panel
―Rear cover
―Right/left side covers
―Fuel tank
―Inverter unit, engine bed
―Recoil starter, fan cover
―Inlet/Exhaust side baffle
23
To Next Page
Loading...
