DP480 Service Manual
19
5.7.Settings
The radio has been set before delivery. However, to meet customers’ requirements, it may be necessary to
set such digital functions as operating frequencies, channels, DT/DQT and automatic scan. This can be
achieved by the programming software CPSM Vx.xx developed by Kirisun. It is user-friendly and easy to
operate, and supports Chinese and English.
To set the parameters of the radio using the software, take the following steps.
Step 1.Install the CPS software on your PC.
Step 2.Connect the radio to the PC using the programming cable.
Note:
Make sure the radio is powered on.
Step 3.While connecting the programming cable for the first time, please install its driver.
Step 4.Run the CPS software Kirisun CPSm_VX.XX.
Step 5.Click Setting → Communication Port, and select the serial port to which the programming cable is
connected.
Step 6.In the software, select Program → Read Data. In the prompted dialog box, click Read. The radio
parameters will be read.
Step 7.In the software interface, modify parameters, select Program → Write Data. In the prompted dialog
box, click Write. The radio parameters will be written.
5.8.Upgrade
To upgrade the radio program using the software, take the following steps.
Step 1.Power off the radio. Connect the radio to the PC using the programming cable.
Note:
While connecting the programming cable for the first time, please install its driver.
Step 2.Double click the upgrade tool as shown below.
DMR Software Upgrade Tool.exe
Note:
This tool upgrades firmware while retaining the previous programming and calibration data.
Step 3.The interface as shown below will be displayed.
To Next Page
Loading...
Need help?
General
