Kirisun DP480 - 7. Features and Operation; TOT (time-out-timer); Channel Scan

DP480 Service Manual
4
NO.
Programming
Function
Function Description
To go back to the previous state, press the key again.
6
Emergency On
Send an emergency alarm. It is used to seek help under emergency.
7
Emergency Off
Exit emergency alarm.
8
Squelch On/Off
Under analogue channel, open voice reception path to receive weak
signals.
Under digital channel, no response when this key is pressed.
9
Zone Selection
Switch to next zone.
10
Scan
Start/stop scanning other channels and receive traffic from them.
11
Alert Tone On/Off
Enable/disable all alert tones.
12
Nuisance Delete
Delete an unnecessary channel (e.g. interference channel) dwelled
on during scan, and then continue scan.
13
Repeater/Talk
Around
On a repeater channel, press it to enter/exit repeater mode.
2.3.LED Indicator
LED Indication
Radio State
Red light on
Transmitting signals.
Green light on
Receiving signals.
Red Light Flashing
Low battery. Please charge it.
Green Light Flashing
Scanning channels
Orange Light Flashing
In call hold state under digital mode. Exit when hold time is up.
Orange Light on
The channel unusable. Switch to another channel to quit.
Red Light Flashing Fast
CPS is reading configurable parameters of the radio.
Green Light Flashing Fast
CPS is programming configurable parameters of the radio.