4-3
5. To remove a burner base and an igni-
tor:
a) Remove the gas line from the burner
base.
b) Disconnect the wire from the ignitor.
c) Remove the two hex-head screws from
the burner base bracket and position
the assembly so that you can access
the ignitor screw.
d) Remove the screw from the ignitor and
remove the ignitor from the burner base.
e) Remove the two hex-head screws from
the burner base and remove the base
from the bracket.
Gas Line
Ignitor Wire
Screw
Screw
Ignitor Screw
Burner Base Screws
To Next Page
Loading...
