4-12
REMOVING THE MAIN ELECTRONIC CONTROL
1. Turn off gas supply and disconnect power
to the range.
2. Remove the two oven doors (see page
4-26 for the procedure).
3. Remove the two screws from the left and
right front side panel trim pieces, then pull
the trim forward, and remove it.
WARNING
Electrical Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Fire Hazard
Shut off gas supply line valve
before servicing.
Check all gas line connections
and replace all parts and panels
before operating.
Failure to do so can result in
explosion, fire or other injury.
4. Remove the three screws from each end
of the bottom trim and remove the trim.
Left Side Panel Trim
Right Side Panel Trim
Screw (1 of 2)
Screw (1 of 2)
5. Remove the two screws from the front of
the main electronic control drawer, lo-
cated below the left side of the unit, and
pull the drawer out.
3 Bottom Trim Screws
Pull Drawer Forward
Main Electronic Control
Drawer Screws
To Next Page
Loading...
