4-21
REMOVING THE SUPPRESSOR BOARD
5. Remove the two screws from the suppres-
sor board.
6. Disconnect the wires from the terminals
and remove the board from the range.
Suppressor Board
2 Screws
1. Turn off gas supply and disconnect power
to the range.
2. Pull the range out of its mounting location
so that you can access the rear of the unit.
3. Remove the top and center braces from
the back of the range (see page 4-17 for
the procedure).
4. Remove the blower motor assembly cover
(see page 4-20 for the procedure).
WARNING
Electrical Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Fire Hazard
Shut off gas supply line valve
before servicing.
Check all gas line connections
and replace all parts and panels
before operating.
Failure to do so can result in
explosion, fire or other injury.
Suppressor Board
To Next Page
Loading...
