EasyManuals Logo

KitchenAid KUDD03DT Series User Manual

KitchenAid KUDD03DT Series
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
3-5
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is le ss than the recommended temperature or food soils are heavy, th e cycle
will automatically compensate by adding time, heat and water as needed.
To run your dish washer at
a later time or during o-
peak hours.
Delays the start of a cycle up to 4hours.
Select a wash cycle and options. Press 4 Hour Delay. Press
START/RESUME. Close the drawer rmly.
All cycles, except Rinse
Only
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
To turn on Lock, press and hold ProDry for at least
4seconds.
To turn o Lock, press and hold ProDry for at least
4seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light ashes
3times. The dishwasher drawer can be opened while the
controls are locked.
Anytime
OPTION SELECTIONS
:HTIW ESUSNOITPIRCSEDSEPYT DAOL HSIDSNOITPO
CONTROLS AND
CYCLESTATUS
CONTROL PURPOSECOMMENTS
To start or resume a
wash cycle
If the drawer is opened during a cycle or the power is interrupted, the Start/Resume indicator
ashes. The cycle will not resume until the drawer is closed and Start/Resume is pressed.
To cancel wash
cycle
Close the drawer rmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
To follow the
progress and status
of your dishwasher
cycle
Clean indicator glows when a cycle isnished.
If you select the Sani Rinse option, when the Sani Rinse cycle is nished, the Sanitized indicator
glows. If your dishwasher did not properly sanitize your dishes, the light ashes at the end of the
cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required
temperature. The light goes o when you open and close the drawer or press CANCEL.
Rinse aid low indicator light glows when the rinse aid dispenser needs to be relled.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KitchenAid KUDD03DT Series and is the answer not in the manual?

KitchenAid KUDD03DT Series Specifications

General IconGeneral
BrandKitchenAid
ModelKUDD03DT Series
CategoryDishwasher
LanguageEnglish

Related product manuals