DANGER!
HAZARDOUS AIR PRESSURE IS PRESENT IN THE HOIST, IN THE SUPPLY OF COMPRESSED AIR TO THE
HOIST, AND IN THE CONNECTIONS BETWEEN COMPONENTS.
Before performing ANY maintenance on the equipment, de-energize the supply of compressed air to the
equipment, and lock and tag the supply device in the de-energized position. Refer to ANSI Z244.1, “Personnel
Protection - Lockout/Tagout of Energy Sources.”
Only trained and competent personnel should inspect and repair this equipment.
NOTICE!
It is the responsibility of the owner/user to install, inspect, test, maintain, and operate a hoist in accordance with
ANSI/ASME B30.16 regulations. If the hoist is installed as part of a total lifting system, such as an overhead crane or
monorail, it is also the responsibility of the owner/user to comply with the applicable ANSI/ASME B30 volume that
addresses that type of equipment.
It is the responsibility of the owner/user to have all personnel that will install, inspect, test, maintain, and operate a
hoist read the contents of this manual and applicable portions of ANSI/ASME B30.16 regulations. If the hoist is
installed as part of a total lifting system, such as an overhead crane, the applicable ANSI/ASME B30 volume that
addresses that type of equipment must also be read by all personnel.
If the hoist owner/user requires additional information, or if any information in the manual is not clear, contact Kito or
the distributor of the hoist. Do not install, inspect, test, maintain, or operate this hoist unless this information is fully
understood.
A regular schedule of inspection of the hoist in accordance with the requirements of ANSI/ASME B30.16 should be
established and records maintained.
To Next Page
Loading...
Need help?
General
