Display messages & solutions
Check the yellow emergency button on startup side of operator console.
If you interrupt a cut by pushing the Cycle Stop button it may be
necessary to restart the system.
Push F3 to restart pneumatic system.
Check air support
User Parameters
Customized parameters may be utilized as desired. To access, push ENTER + F6
Enter the code 0000
01 - Language, select 1 of 5 languages
Push ENTER button to scroll through the various languages Note: English is ING
Scroll down through the list of parameters with the 'down'
arrow shown at right
02 - Blade thickness - may changed to match your blade
thickness (keft removal) Enter number and decimal at keypad
03 - Hydraulic timeout - may be adjusted to shut down hydraulic system after set level of idle activity,
adjustable in minutes. Enter time in minutes at keypad
04 - Blade shut off - blade can be set to run continually or shut off when cycling
05 - Sawframe travel - Semi-automatic operation only; shut off at bottom of cut or shut off when
sawframe reaches top
09 - Unit of measure - Chose between inch or metric
To Next Page
Loading...
General