MAINTENANCE
DAILY
-Clean all chips from machine
-Replenish Coolant Level
-Inspect all blades for wear, and send full blades out for resharpening
WEEKLY
-Clean all chips from machine. Thoroughly clean vise area, and lubricate with quality lubrication
-Lubricate prismatic column by applying light grease directly onto the column ways
-Check Blade Cleaning Brush (see below)
MONTHLY
-Check column adjustment after first 100 hours; then yearly See description below.
SAW FRAME
The saw frame fits on its column ways similar to the fit of the vise described above, and if looseness is
suspected, the adjustments are identical. (See #1) Again, do not overtighten, or the saw frame will move
with great difficulty, and excessive wear will occur.
Column Lubrication (#2) needs to be greased monthly. Note: If you do
not have a grease gun for this type of fitting, please note it is called a
“flush-style” grease fitting (with an M8 thread). You will also find tips
(adapters) are available that will attach to your standard manual grease
gun.
To Next Page
Loading...
General