Locate recommended blade from list
Special Sawblade Grinds
All standard blades are ground for use on mild steels.
Blades to be used on stainless steels (or other hard materials) should be designated with an “SS” after the part
number (ex: 1404 SS) These blades may also be used on mild steels
Blades to be used on aluminum or other non-ferrous materials should be dsignated with an “AL after the part
number (ex: 1410 AL) These blades may not be used on steels.
Overloading
The machine is equipped with a thermal motor protector in case of overload. This device is built into the machine
main power disconnect, and is adjustable. If machine frequently goes into overload, you may adjust the
amperage to a slightly higher setting by removing cover and turning adjusting screw.
To Next Page
Loading...
General