SPECIFICATIONS
Model C 370 SA-V
Drive Motor 4 HP, TEFC
Spindle RPM 13-76 RPM, Infinitely Variable
Blade Data
Max diam 14 1/2" (370mm)
Spindle diam 40mm
Pin diameter 10mm
Pin locations 63mm
Max Vise Opening 7"
Work Height 36"
Power Requirements
208-220-230 volts - 20 amps
440-460 volts - 12 amps
3 phase
60 cycles
Air Connection 3 CFM 60-100 PSI
Coolant Capacity 3.5 Gal (15 lit)
Gearbox Capacity-main 1 Gal (5.5 lit)
Hydraulic Capacity 45 oz (1.6 lit)
SAFETY INSTRUCTIONS
TO THE OWNER OR SUPERVISOR
You must remember that this machine is designed to cut metal with a sharp tool, and you are responsible to see
that the machine is in top operating condition and that it is operated IN A SAFE MANNER!
YOU MUST:
1. Make sure the machine is properly installed, anchored to floor, and electrical installation is proper.
2. Be sure you are familiar with all operating, safety, and applications information before operating this
machine or turning it over to one of your employees.
3. See that all who operate this machine are properly trained and fully aware of all safety practices.
4. Be aware of all unsafe practices that may occur. (See operator safety precautions and applications
information)
5. Insist on proper personal protective equipment and practices.
6. Maintain all factory installed safety devices and insure that these are never removed or altered or
restricted in any way.
7. Insure that your operators have a safe and orderly work area, with adequate light and operating room.
8. Be certain that your machinery receives responsible and competent maintenance and that your
machinery is inspected on a regular basis.
YOU ARE RESPONSIBLE
To Next Page
Loading...
General