ELECTRICAL CONNECTION
Only a qualified electrician should do electrical connections!
Make sure your power supply matches the machine.
Note: Machine is supplied with isolation transformer to match your operating voltage.
All machines operate at 400 volts, and you must have the correct transformer to operate on your power supply.
Voltage may be changed at isolation transformer.
It is recommended that the machine is on a circuit that is properly fused, and the machine must be properly
grounded to comply with OSHA and state electrical codes. If your machine is installed in an area subject to
voltage spikes or high variations you will need to install a Line Reactor rated at 11 amps.
Next, check the machine for proper rotation. If rotation is not correct, change any two of the three power leads at
point of connection.
Note: Yellow & Green Wires are Ground
Foot Pedal Connection
Note that on the back of the operators console you will find a female plug receptacle. If you desire to operate with
a footswitch, you may wire into the plug at this point. Use of a foot pedal will then actuate a semi-automatic
sawing cycle (same as pushing “cycle start” button)
WIRE SIZES
The machine must be serviced by adequate wire or a severe loss of power may occur, leading to poor
machine performance. We recommend:
Length of conductor Wire Gauge Size
50' or less #14
100" or less #12
100-150" #10
150 or longer NOT RECOMMENDED
To Next Page
Loading...
General