How to troubleshoot low cutting water supply pressure on a KMT Streamline SL-V 30 Plus Cutter?
To troubleshoot low cutting water supply pressure: * Check for a restricted water supply by verifying cutting water supply flow and pressure. * Inspect for a clogged water filter and replace the filter element if necessary. * Bleed any trapped air from the cutting water plumbing.
What causes high oil temperature resulting in shutdown in KMT Streamline SL-V 30 Plus?
High oil temperature leading to a shutdown can be caused by: * Restricted cooling water flow, so check the cooling water source for proper temperature and flow rate. * A water modulating valve stuck open or closed, in which case you should replace the valve. * Scale build-up in the heat exchanger restricting the flow, so the heat exchanger will need to be flushed or replaced. * Air cooler temperature switch not operating properly, so replace the switch. * No power to cooler fan motor, so check the power supply to the fan motor.
What to do if the console display and lights do not illuminate on KMT Streamline SL-V 30 Plus?
If the console display and lights do not illuminate, check for the following: * Ensure the emergency stop button is not depressed; pull it out if it is. * Verify main power is connected and the main power disconnect is on. * Check the power supply circuit for a tripped breaker. * Check the input and output of the 24 volt DC power supply. * Check the 2K1 relay.
Why is there no control power to my KMT Streamline SL-V 30 Plus?
If there is no control power, the possible causes are: * A tripped circuit breaker, so check the input and output of all circuit breakers. * A power supply fault, so check the input and output voltages at the power supply. * The emergency stop button is depressed, so pull the e-stop button out. * The master control relay is not energized, so verify that the contactor coil is pulling in on the master control relay. * Contact set failure on the master control relay, so verify that the contact sets on the master control relay are changing states when the relay is energized.
What to do if the KMT Streamline SL-V 30 Plus Cutter pump quits running?
If the pump quits running, it could be due to: * Unsafe operation being detected, so check the display panel for fault messages. * Electrical power interruption, so check the power supply circuit for a tripped breaker. * Check the input and output of the 24 volt DC power supply. * Verify that power is available at the main power source. * Check the 2K1 relay coil. * Check the 4K0 relay. * The motor overload relay has been tripped; identify the source of the overload, remedy the problem, and reset the overload relay.
General| Model | SL-V 30 Plus |
|---|---|
| Category | Cutter |
| Max Operating Pressure | 60, 000 PSI |
| Abrasive Flow Rate | 0.5-1.5 lb/min |
| Cutting Width | 0.04 inch |
| Cutting Speed | Dependent on material and thickness |
Outlines critical safety precautions, hazards, and lockout/tagout procedures for operation.
Details compliance with electrical codes and specifies voltage and ampacity requirements.
Emphasizes routine and preventive maintenance for optimal operation and reliability.
Highlights critical safety precautions and procedures before performing maintenance.
Details the startup procedures based on previous stop conditions.
Lists alarms displayed on the Run Screen and their indications.
Details routine servicing and maintenance for filter, strainer, and booster pump.
Covers routine servicing and maintenance for the main hydraulic system components.
Details routine inspection and maintenance for the hydraulic system components.
Provides general guidance on high pressure water system maintenance procedures.
Provides a guide to diagnose problems by observing sounds and operating conditions.
To Next Page
