KÖCO KST 108 - The Power Source; Technical Data of KST 108 and KST 110 Power Sources

2.1 The Power Source
The power source consists of a one-phase transformer, a capacitor accumulator, a welding thyristor, a dis-
charge resistor, a charging connection with a rectifier, and an electronic control system. The standard model
is laid out for a 230 V mains input voltage.
2.2 Technical Data of KST 108 and KST 110 Power Sources
Technical data
KST 108
KST 110
tip ignition stud welding (gap or contact welding),
welding range Ø (mm)
3 - 8
3 - 10
nominal capacity (mF)
66
99
loading voltage range (infinitely adjustable) app. (V)
50 - 200
50 - 200
max. studs/min. for ... Ø (mm)
10 / 3
4 / 6
10 / 3
4 / 8
mains power supply 50/60 Hz, 1-phase current (V)
115 or 230
115 or 230
mains connection plug for 230 V (A)
16
16
mains connection cable, 3-pole, for 230 V (m/mm
2
)
3/1.0
3/1.0
mains time-lag fuse for 230 V (A)
6.3
6.3
mains input at 230 V (W)
700
700
class of protection
IP 23
IP 23
cooling
F
F
operational temperature range (°C)
0 - 50
0 - 50
housing dimensions (L x W x H) mm without
handles and legs
330 x 190 x 280
330 x 190 x 280
weight (app. kg)
8.9
9.9
Approved for operation under increased electrically hazardous
conditions, CE labelling according to EN 60974-1
Issue 4/2019 ver. 2.0 page 10 of 42
Köster & Co. GmbH • D-58256 Ennepetal • Spreeler Weg 32 • Tel. +49 2333 8306-0 • Fax +49 2333 8306-38
Internet: http://www.koeco.net • E-Mail: koeco@koeco.net